SW500 Wired Scale System
700431
Rev G, December 2021
Page 17
INDICATOR OVERVIEW
Baseline Setup (continued)
TARGET %
Manually entering values in the Target % format enables targets to be set with the
following parameters: Left Front %, Right Front %, Left Rear %, Right Rear %.
1. Press the STORE/ENTER key to enter a target setup.
2. Enter setting 00. Press the STORE/ENTER key.
3. Press the 3 key to select the Target % format.
4. Enter the Total Weight.
5. Enter the Left Front %.
6. Enter the Right Front %.
7. Enter the Left Rear %.
8. Enter the Right Rear %.
9. Enter a memory location (1-99) to save the target setup entry in.
10. The screen will return to Normal weighing mode.
The screen will display the targets entered. Press the ACTUAL key or the
COMPARE key to view the actual weight on the scales or to compare the targets
entered to the weights on the scales.
RECALL BASELINE SETUP
To recall one of the 99 setups, use the numeric keypad to access a memory location
between 0-99. The following menu will be displayed. In this example, memory location
06 was selected.
Enter the desired memory location number. Press the STORE/ENTER key. The scale
automatically switches to TARGET mode to display the stored setup. Press the
ACTUAL key to view the current weights on the scales. Press the COMPARE key to
display a comparison of the current weights to the target weights.
RECALL SETUP FROM
MEMORY#1-99: 06
(HIT ACTUAL TO EXIT)
To Next Page
Loading...
