Setup and User Guide 11
Providing a brighter solution.™
Adding or “Including”
Make sure the lamp plugged into the module
is switched ON, then press and release the
PROGRAM button (the black button) on the
module till the lamp comes ON. The green LED
on the module will blink.
Put the HA07 into
INCLUSION mode by
pressing and releasing
the INCLUDE button
on the HA07. This time, the word “INCL” will
appear on the screen and “TRANSMITTING”
will begin to flash in the upper right corner.
NOTE: If TRANSMITTING stops flashing, just
press the INCLUDE button again.
Press and release the PROGRAM button on the
module to add it to the network.
If the inclusion was
successful, the word
“SUCCESSFUL” will
show for 2 seconds
and the light will go
OFF.
If “NOT SUCCESSFUL” appears on the
screen, return to Step 1 and repeat.
Repeat the Deleting and Adding procedures
shown on pages 11 and 12 for each module you
wish to add to the network.
(For non-HomeSettings modules, refer to the
instructions provided by the manufacturer.)
1.
2.
3.
•
•
4.
To Next Page
Loading...
