To Next Page

To Previous Page

8 HomeSettings HA07 Wireless Master Controller

Setting up your network

Before you begin…

Creating your network means to assign or

“include” individual HomeSettings modules to the

HA07 Master Controller. Modules must be assigned

to the master controller before any programming or

remote control functions can be accomplished.

Before setting up your network or programming the

buttons on the HA07 Master Controller, make sure

you do the following:

Plug in or hard wire the individual HomeSettings

modules in the permanent location where you

will be using them.

Plug devices (for example, lamps) into the

modules during network setup and the

programming of control buttons.

Make sure these devices (lamps) are turned ON.

For best results, do not move or relocate modules

after they have been included into the network.

If you wish to re-locate or move a module from a

particular location, ﬁrst delete it from the network,

then include it back to the network after you have

re-located it.

NOTE: HA06, HA14 and HA20 Dimmer Switches

have a 40-Watt minimum lamp requirement.

NOTE: Compact ﬂuorescent bulbs should not be

used with dimming modules such as HA03, HA05,

HA06, HA14, and HA20.

•

Setting up your networkSetting up your network

Intermatic HA07 User Manual

Other manuals for Intermatic HA07