38 HomeSettings HA07 Wireless Master Controller
Copyright © 2007 Intermatic, Inc.
NOTE: If “NOT SUCCESSFUL” appears on
the HA07 screen, repeat these steps until the
procedure is successful.
On the SECONDARY controller (if HA09):
Press and hold the INCLUDE button for 5 seconds.
The two LEDs will flash at the same time.
Release the INCLUDE button.
Press and release the ON/DIM▲ button for
Channel 1. The controllers will automatically
synchronize with each other and the LED will
show a solid green light for 2 seconds.
NOTE: If the red and green LEDs flash for two
seconds, the procedure was not successful.
Repeat these steps until the procedure is
successful.
Duplicating the network only
This feature allows you to customize the Secondary
Controller while using the same network as the
Primary Controller
Follow the same procedure as Duplicating network
and channel settings on another controller, except:
With the Primary Controller, press the ON/DIM▲
button for Channel 2 instead of Channel in
Step 3.
With the Secondary Controller, press the ON/
DIM▲ button for Channel 2 instead of Channel in
Step 3.
1.
2.
3.
•
•
To Next Page
Loading...
