Need help?Do you have a question about the Intermatic HA07 and is the answer not in the manual?
General| Protocol | Z-Wave |
|---|---|
| Voltage Rating | 120 VAC |
| Battery Backup | No |
| Indoor/Outdoor | Indoor |
| Compatibility | Z-Wave |
| Load Rating | 1800W (15A) Resistive |
| Mounting | In-Wall |
Prepare for network setup by ensuring modules are plugged in and devices are turned on.
Follow on-screen instructions for linking modules, creating scenes, and setting time/date.
Prepare modules by excluding them from the network and then including them.
Assign modules to specific ON/DIM and OFF/DIM buttons to create scenes.
Configure non-dimming modules to respond to the ALL ON and ALL OFF buttons.
Introduction to setting the controller's time, date, and automatic adjustments.
Understand automatic daylight savings, sunrise/sunset adjustments, and exact time settings.
Detailed instructions for setting the current hour and minute on the controller.
Detailed instructions for setting the month, day, and year on the controller.
Configure automatic daylight saving time adjustments or disable the feature.
Set the geographical zone to adjust sunrise/sunset times for accurate lighting control.
Manually input precise sunrise and sunset times for tailored lighting automation.
Create events to turn lights ON automatically at sunrise or sunset based on astronomical data.
Create events to turn lights OFF automatically at sunrise or sunset based on astronomical data.
Schedule lights to turn ON at a user-defined specific time and day.
Schedule lights to turn OFF at a user-defined specific time and day.
Guide to setting up additional timer or astronomic-controlled events.
Procedure for modifying existing timer or astronomic-controlled events.
Select between AUTO, AUTORAND, or MANUAL modes for controller operation.
Instructions for manually turning channels ON/OFF or dimming lights.
Important information regarding controller capabilities and limitations.
Clear network settings from the controller, preparing it for a new network configuration.
Clear channel settings from the controller, resetting scene associations.
Completely reset all clock, event, channel, and network settings on the controller.
To Next Page
