Setup and User Guide 43
Providing a brighter solution.™
Troubleshooting
The Troubleshooting issues addressed below are
the most common problems encoubntered. For the
latest listing of troubleshooting issues, go to www.
intermatic.com/[do we have a place?]
Issue Possible Solution
Every time I try to
INCLUDE or DELETE
modules to my
network, I keep
getting errors (red
LED flashes)
The controller might be a Secondary
Controller. Only a Primary Controller
may be used to INCLUDE or
DELETE modules into or from a
network. Use the Primary Controller
to INCLUDE or DELETE.
The module might be part of a
different network. Reset the module
by pressing and releasing DELETE
on the primary controller, then push
the program button on the module.
Now you may INCLUDE the module
using the Primary Controller. (See
page 11).
•
•
After I perform
a controller
replication, neither
controller controls
anything at all.
You have copied from the wrong
controller and overwritten your
primary controller. You must
reprogram the primary controller.
•
TroubleshootingTroubleshooting
To Next Page
Loading...
