Intermatic HA07 - Programming Scenes; Associating Modules to Scenes

Setup and User Guide 13
Providing a brighter solution.™
Programming channel “scenes”
After creating your network, you’ll want to set up
which ON/DIM and OFF/DIM buttons control which
modules.
A “scene” is one or more modules that are set to
specific levels and controlled by a specific pair of
ON/DIM and OFF/DIM buttons on the HA07 Master
Controller. For example, you could set up handy
scenes that contain:
All the lights in your living room
The lights in the kids’ rooms upstairs that they
always leave on
All your outdoor lights
Each pair of buttons is also called a “Channel”.
Before you begin, make sure all modules you’re
planning to include in the scene have a lamp or
other device plugged in or connected.
Associating (or adding) modules to a scene
Use the instructions in this section to associate a
module to a channel on the master controller.
If necessary, make sure any lamps connected to
modules are switched on.
Press the PROGRAM button (the black button) on
the module to make sure the LED on the device
is lighted.
•
•
•
1.
2.
Programming channel “scenes”Programming channel “scenes”