Intermec EasyCoder C4 User Manual

16 Intermec EasyCoder C4—User’s Guide
Chapter 2— Operation
7 Route the media through the slits in the front edge guides
8 Firmly close the top cover.
9 If loading media for the fi rst time or if changing from another type or
size of media, perform a Label Gap Sensor Adjustment as described
on page 24. Else, tap the Feed key either 4 times or until the indicator
lamp glows green.
10 If the printer did run out of media while printing, the printing will
automatically be resumed. Else, tear off excessive media by pulling it
upwards against the tear bar.
Tear off the media upwards against the tear bar.

Intermec EasyCoder C4 Specifications

General

Brand	Intermec
Model	EasyCoder C4
Category	Printer
Language	English