52 Intermec EasyCoder C4—User’s Guide
Appendix D—Firmware Upgrading
6 Press the Feed key and keep it pressed and at the same time switch
on the power to the printer (also see “Test Mode” on page 24). A test
label will be printed. Check the version number on the test label to
verify that the upgrading has been successful.
7 Tap the Feed key once to leave the Dump Mode and return to normal
operation.
8 You can use the same memory cartridge to upgrade several printers by
moving the cartridge from printer to printer and repeat this procedure
for each printer. Be careful not to change the position of the memory
cartridge switch until all printers have been upgraded.
9 The cartridge can be used as a normal memory expansion cartridge
after the upgrading is completed. Move the switch back to normal
position, insert the cartridge in a printer, and switch on the printer.
The memory cartridge will then be formatted automatically.
To Next Page
Loading...
