Intermec EasyCoder PF2i User Manual

Chapter 10 — Troubleshooting
EasyCoder PF2i Bar Code Label Printer User’s Guide (Fingerprint Version) 99
Large part of dot
line missing
Failing printhead Replace
printhead
“Printhead
Replacement”
on page 109
Failing strobe
signal
Check CPU-
board
 Call Service
Wrong X-Start or
Width parameter
Change
parameter
“Setting Up
the Printer” on
page 49
Printout missing
along inner edge
Bad media
alignment
Adjust “Media Load”
on page 25
Small core &
supply post in
upper pos.
Move post to
lower pos.
“Media Supply
Positions” on
page 10
X-Start
parameter value
too low
Increase “Setup
Parameters” on
page 52
Transfer ribbon
breaks
Ribbon not fitted
correctly
Reload ribbon “Ribbon
Load” on
page 42
Wrong media
grade
Change
parameter, then
clean printhead
“Setup
Parameters” on
page 52,
“Printhead
Cleaning” on
page 102
Bad energy
control
Adjust
 Call service
Transfer ribbon
wrinkles
Faulty ribbon
break shaft
adjustment
Adjust “Ribbon Break
Shaft
Adjustment”
on page 1231
Incorrect edge
guide adjustment
Adjust “Media Load”
on page 25
Too s tr ong
printhead
pressure
Adjust “Printhead
Pressure
Adjustment”
on page 121
List of Problems and Remedies (continued)
Symptom Possible Cause Remedy Refer to

Intermec EasyCoder PF2i Specifications

General

Brand	Intermec
Model	EasyCoder PF2i
Category	Printer Accessories
Language	English