Intermec EasyCoder PF2i - Page 115

Chapter 10 — Troubleshooting
100 EasyCoder PF2i Bar Code Label Printer User’s Guide (Fingerprint Version)
No thermal
transfer printout
Ink-coated side
does not face
media
Reload ribbon “Ribbon
Load” on
page 42
Media feed not
working properly
Change media
characteristics
Press the Print
button
“Media Load”
on page 25
Wrong label rest
dots parameter
Check/change “Setup
Parameters” on
page 52
Wrong Media
Type parameter
Check/change “Media” on
page 56
Wrong LSS
position
Check/change “Media” on
page 56
Dirty sensors Clean media
guides
“Cleaning the
Media Guides”
on page 107
Faulty sensors Replace
 Call Service
Compressed text
or bar code
Too high speed
for large media
roll
Lower print
speed
“Media” on
page 56
List of Problems and Remedies (continued)
Symptom Possible Cause Remedy Refer to