Chapter 12 — Adjustments
120 EasyCoder PF2i Bar Code Label Printer User’s Guide (Fingerprint Version)
(with GAPS);TICKET (with MARK), TICKET (with
GAPS), FIX LENGTH STRIP; or VAR LENGTH STRIP.
• Perform a TESTFEED by simultaneously pressing the Shift
and Feed keys on the printer’s keyboard.
• Make sure that there is a label—not a gap or mark—at the
LSS.
• Check that the media is routed as close to the center section as
the guides allow.
• Enter the Setup Mode (see “Setup Mode” on page 67) and go
to Setup Mode/Print Defines/LSS Test/LSS Auto.
• The menu should look like this with the cursor placed in the
center:
• Gap or slot detection:
Lift the printhead and pull out the media slowly. When the
LSS detects a gap or a detection slot, the cursor moves to the
right.
• Black mark detection:
Lift the printhead and pull out the media slowly. When the
LSS detects a black, the cursor moves to the left.
• It is possible to refresh the centered cursor position by
pressing the d/F4 key.
• If the cursor behaves as described above, the LSS is working
and is properly aligned with the gaps, slots, or black marks.
LSS Auto
LSS Auto
LSS Auto
To Next Page
Loading...
