To Next Page
S
staceyosborneNov 16, 2025
How to fix an overall weak printout on my Intermec Barcode Reader?
- JJulie QuinnNov 16, 2025
If your Intermec Barcode Reader is producing an overall weak printout, several factors could be responsible. The paper type might be incorrect, so try changing the parameter. The contrast value or printhead pressure could be too low, requiring adjustment of the corresponding parameter. A worn printhead or platen roller can also cause this issue, necessitating replacement. In some instances, the wrong printhead voltage may be the cause, which would require replacing the CPU board. Uneven printhead pressure can be resolved by adjusting the arm alignment. Ensure that foreign particles are not present on the media; clean or replace the media if necessary. Verify that the media and ribbon are compatible; if not, switch to matching media. The issue might stem from poor media or ribbon quality, i...
General
