Intermec PC23d

Chapter 1 — About the Printers
PC23 and PC43 Desktop Printer User Manual 19
Set the Command Language from the Printer Web Page
The printer uses Fingerprint by default. Follow this procedure to
change the command language from the printer web page.
1 On your PC, open a browser.
2 In the Location or Address bar, type the printer IP address and
press Enter. The printer web page appears.
3 Click Login. The Login page appears.
4 Type your Username and Password and click Login. The default
username is itadmin and the default password is pass.
5 Click the Configure tab.
6 Click System Settings > General.
7 Select a different printer command language from the Command
Language list, and then click Save.
8 Click the Services tab.
9 Click Reboot Printer, and then click Reboot. The printer restarts
in the command language you selected.
Set the Command Language from the Main Menu
The printer uses Fingerprint by default. Follow this procedure to
change the command language from the printer Main Menu.
1 From the Ready screen, press . The Main Menu appears.
2 In the Main Menu, select Settings > System Settings > General.
3 In the General settings list, press to scroll to Command
Language.
4 Press or to select a different command language.
Note: To use this procedure, the printer must be connected to your
Ethernet or Wi-Fi network.
Note: If you are using an icon printer without an Ethernet or Wi-Fi
network, you must use PrintSet to set the default printer command
language.