Chapter 2 — Set Up the Printer
40 PC23 and PC43 Desktop Printer User Manual
Load Media for Cut-Off Printing
For cut-off printing, you must install the automatic cutter accessory.
You can print on non-adhesive, continuous label stock. You can also
use self-adhesive labels with a liner, but you must cut only the liner.
Each label is automatically cut from the media roll immediately after
the label is printed. The optional cutter tray accessory installs on the
front of the cutter and holds up to 20 labels or tickets.
1 Pull one or both of the printer latches toward the front of the
printer and lift the printer lid.
2 If there is an empty media core in the media compartment, remove
the core.
3 If you are going to load the same size media, continue with the next
step.
If you are using large rolls of media stored outside the printer, such
as in an external media holder, feed the media through the external
media feed slot.
Note: Cut-off printing is supported only by the PC43 printer with the
cutter module installed.
To Next Page
Loading...
