Intermec PC23d

Chapter 2 — Set Up the Printer
PC23 and PC43 Desktop Printer User Manual 39
7 Turn the printer on and adjust the media feed as required. Intermec
recommends the following values for straight-through or tear-off
printing:
Recommended Feed Adjust Values for PC23d
Setting 203 dpi 300 dpi Distance
Start Adjust -113 -168 -14.24 mm (-0.56 in)
Stop Adjust 0 0 0 mm (0 in)
Recommended Feed Adjust Values for PC43d
Setting 203 dpi 300 dpi Distance
Start Adjust -124 -183 -15.50 mm (-0.61 in)
Stop Adjust 0 0 0 mm (0 in)
Recommended Feed Adjust Values for PC43t
Setting 203 dpi 300 dpi Distance
Start Adjust -108 -160 -13.60 mm (-0.54 in)
Stop Adjust 0 0 0 mm (0 in)
Note: These settings allow for printing from the top edge of the label.
You may need to adjust the recommended values slightly depending
on your media type, supply method, and roll sizes, or because of
individual differences between printers.