Chapter 2 — Set Up the Printer
44 PC23 and PC43 Desktop Printer User Manual
8 After the printer finishes starting up, press .
9 Select Settings > Printing > Cutter .
10 In the Cutter Control options, select Automatic.
11 Press or . A “Save Changes?” message appears.
12 Press to save your changes and exit the Settings menu.
13 Adjust the media feed as required. Intermec recommends the
following values for cut-off printing:
Note: If you are using an icon printer, you must use Intermec PrintSet
to configure the cutter. For LCD printers, continue with the next step.
Recommended Feed Adjust Values for PC43d
Setting 203 dpi 300 dpi Distance
Start Adjust -294 -434 -36.80 mm (-1.45 in)
Stop Adjust 170 251 21.3 mm (0.84 in)
Recommended Feed Adjust Values for PC43t
Setting 203 dpi 300 dpi Distance
Start Adjust -372 -550 -46.60 mm (-1.45 in)
Stop Adjust 264 389 33 mm (0.84 in)
Note: You may need to adjust the recommended values slightly
depending on your media type, supply method, and roll sizes, or
because of individual differences between printers.
To Next Page
Loading...
