Intermec PC23d

Chapter 2 — Set Up the Printer
PC23 and PC43 Desktop Printer User Manual 49
8 Route the liner through the slot in the front door of the label
dispenser. Do not pull on the media to take up the slack. The liner
should be over the roller in the printer and under the roller in the
front door of the label dispenser.
9 Close the front door.
10 Close the printer lid until it snaps shut.
11 Turn the printer on adjust the media feed as required. Intermec
recommends the following feed adjust values for the label
dispenser:
Recommended Feed Adjust Values for PC23d
Setting 203 dpi 300 dpi Distance
Start Adjust -117 -173 -14.70 mm (-0.58 in)
Stop Adjust 3 5 -0.46 mm (0.02 in)
Recommended Feed Adjust Values for PC43d
Setting 203 dpi 300 dpi Distance
Start Adjust -126 -186 -15.8 mm (-0.62 in)
Stop Adjust 2 3 0.3 mm (0.01 in)