Intermec PC23d

Chapter 2 — Set Up the Printer
66 PC23 and PC43 Desktop Printer User Manual
Clip Default Determines if the printer prints items
outside the printable area of the label.
When this is set to Off, the printer
returns an error if any part of a bar code
label cannot be printed because that part
extends beyond the printable area. When
this is set to On, the printer prints all bar
code labels, but may also print
unreadable, incomplete labels.
Off
Start Adjust Sets the length of media the printer feeds
(positive value) or retracts (negative
value) before printing a label. Unit of
measurement is defined in the Unit of
Measure parameter. Range is -9999 to
+9999.
0
Stop Adjust Sets the length of media the printer feeds
(positive value) or retracts (negative
value) after printing a label. Unit of
measurement is defined in the Unit of
Measure parameter. Range is -9999 to
+9999.
0
Media Calibration
Mode
Selects the mode the printer uses to
calibrate media. Use Slow if the printer
has trouble identifying gaps or marks in
media.
Fast
Length (Slow
Mode)
If Media Calibration Mode is set to Slow,
the printer prints the media length plus
10 mm. This value sets an additional
amount of media to be printed. Unit of
measurement is defined in the Unit of
Measurement parameter. Range is 0 to
3200.
0
LTS Sensitivity
Level
Sets the sensitivity of the label taken
sensor. Range is 0 to 14. Supported when
the Cutter or Label Dispenser accessories
are installed.
0
Setting Description Default