Interroll Drum motor series i, S, S/A, D
Safety
Version 4.1 (06/2015) en-US
Translation of original instruction manual
11
4 Never wear jewelery, such as necklaces or bracelets.
4 Do not touch the surface of the drum motor. It can result in burns, even under regular
operating temperature.
4 Do not use the drum motor in explosive atmospheres.
4 Remove equipment or material which is not required from the workspace.
4 Wear safety shoes.
4 Clearly specify and monitor the way materials are placed on the conveyor.
4 Regularly check the drum motor for visible damage.
4 In case of fumes, unusual noise or blocked or damaged materials, stop the drum motor at
once and ensure that the RollerDrive cannot be started accidentally.
4
Contact qualified personnel immediately to find the source of the fault.
4 During operation, do not step on the drum motor or the conveyor/the system in which it is
installed.
4 Check the product regularly for visible damages, unusual noise and firm seating of fittings,
screws and nuts. An additional maintenance is not required.
4
Do not open the drum motor.
4 Take care during installation and maintenance work or in the event of a drum motor fault:
The drum motor could start up unintentionally.
Interfaces to other devices
Hazards may occur while integrating the drum motor into a complete system. These are not part
of this manual and have to be analyzed during the design, installation and startup of the
complete system.
4
After assembling the drum motor in a conveyor module, check the whole system for a new
potential dangerous spot before switching on the conveyor.
4
Additional constructive measures may be required.
Hot motor parts
Working environment
Faults during operation
Maintenance
Accidental motor start
To Next Page
Loading...
Need help?
General
