CHV180 series frequency inverter special for elevator Appendix D
.130.
Appendix D Function parameters
The function parameters of CHV100 series inverters have been divided into 16 groups
(P0~PE) according to the function. Each function group contains certain function
codes applying 3-class menus. For example, “P8.08” means the eighth function code
in the P8 group function, PE group is factory reserved, and users are forbidden to
access these parameters.
For the convenience of function codes setting, the function group number corresponds
to the first class menu, the function code corresponds to the second class menu and
the function code corresponds to the third class menu.
1. Below is the instruction of the function lists:
The first line “Function code”:codes of function parameter group and parameters;
The second line “Name”:full name of function parameters;
The third line “Description”:detailed illustration of the function parameters
The forth line “Factory Setting” : the original factory set value of the function
parameter;
The fifth line “Modify ”: the modifying character of function codes (the parameters
can be modified or not and the modifying conditions),below is the instruction:
“○”: means the set value of the parameter can be modified on stop and running
state;
“◎”: means the set value of the parameter can not be modified on the running
state;
“●”: means the value of the parameter is the real detection value which can not
be modified.
The sixth line “LCD Display”: simple illustration for the function parameters
(The inverter has limited the automatic inspection of the modifying character of the
parameters to help users avoid mismodifying)
2. “LCD Display” is only valid when external LCD operational panel is used.
3.” Factory setting” means the function parameter will restore to the default value
during default parameters restoring. But the detected parameter or recorded value
won’t be restored.
4. For a better parameter protection, the inverter provides password protection to the