F
IGURES
– 33 –
Figure 68: Configuring GVRP for an Interface 178
Figure 69: Showing Dynamic VLANs Registered on the Switch 179
Figure 70: Showing the Members of a Dynamic VLAN 179
Figure 71: QinQ Operational Concept 181
Figure 72: Enabling QinQ Tunneling 185
Figure 73: Adding an Interface to a QinQ Tunnel 186
Figure 74: Configuring Protocol VLANs 188
Figure 75: Displaying Protocol VLANs 189
Figure 76: Assigning Interfaces to Protocol VLANs 190
Figure 77: Showing the Interface to Protocol Group Mapping 191
Figure 78: Configuring IP Subnet VLANs 192
Figure 79: Showing IP Subnet VLANs 193
Figure 80: Configuring MAC-Based VLANs 194
Figure 81: Showing MAC-Based VLANs 194
Figure 82: Configuring VLAN Mirroring 196
Figure 83: Showing the VLANs to Mirror 196
Figure 84: Configuring Static MAC Addresses 198
Figure 85: Displaying Static MAC Addresses 199
Figure 86: Setting the Address Aging Time 200
Figure 87: Displaying the Dynamic MAC Address Table 201
Figure 88: Clearing Entries in the Dynamic MAC Address Table 202
Figure 89: Mirroring Packets Based on the Source MAC Address 203
Figure 90: Showing the Source MAC Addresses to Mirror 204
Figure 91: STP Root Ports and Designated Ports 206
Figure 92: MSTP Region, Internal Spanning Tree, Multiple Spanning Tree 207
Figure 93: Common Internal Spanning Tree, Common Spanning Tree, Internal
Spanning Tree 207
Figure 94: Configuring Port Loopback Detection 209
Figure 95: Configuring Global Settings for STA (STP) 213
Figure 96: Configuring Global Settings for STA (RSTP) 214
Figure 97: Configuring Global Settings for STA (MSTP) 214
Figure 98: Displaying Global Settings for STA 216
Figure 99: Configuring Interface Settings for STA 219
Figure 100: STA Port Roles 221
Figure 101: Displaying Interface Settings for STA 222
Figure 102: Creating an MST Instance 224
Figure 103: Displaying Global Settings for an MST Instance 224
To Next Page
Loading...
