irinox Freddy 60 - Page 42

42 Freddy
Press the key to access the screen for chamber temperature setting
during low temperature cooking phase.
The screen for chamber temperature setting during low temperature cooking
phase will appear. (cooking temperature can be set between +40 °C and +85
°C).
To edit the temperature press the
+
-
keys to increase or decrease the
temperature by 1 °C. If you wish to increase or decrease the time in a faster
manner, use the horizontal dragging. Press the
SAVE
key to conrm the
temperature modication, while press to go back to the previous screen
without saving any change.
Press to access the time editing screen to set the time you wish the
food to be ready.
The delay time setting screen, i.e. the time you wish the food to be cooked,
will appear. The minimum value that can be displayed and set is zero, while
the maximum value is 48 h (these hours relate to the delay, then the time
displayed is the sum of the two times, i.e. low temperature cooking time and
delay time).
To edit the time press the
+
-
keys to increase or decrease the time by 1
minute. If you wish to increase or decrease the time in a faster manner, use
the horizontal dragging.
Press the
SAVE
key to conrm the time modication, while press to go
back to the previous screen without saving any change.
At the end of cooking it is possible to decide whether to keep the food hot, or
blast chill it by selecting the relevant symbol.
The selected icon appears with arrows on the sides and a more intense colour.
Press the
START
key to start the cycle. During the cycle in progress, until low
temperature cooking phase has not started, the time left (countdown) of cold
storage (+2 °C) will be displayed. This time can be edited by pressing .
The screen to change the time you wish the food to be ready will appear; this
screen acts on the cold storage time (+2 °C), as the cooking phase has not
started yet.
To edit the time press the
+
-
keys to increase or decrease the time by 1
minute. If you wish to increase or decrease the time in a faster manner, use
the horizontal dragging.
Press the
SAVE
key to conrm the time modication, while press to go
back to the previous screen without saving any change.
The chamber temperature detected by the air probe is shown at the top
right-hand side of the display .
13:15
SAVE
- +
+
5h:00 70°C 13:15
?
START
+3°C
13:15
SAVE
- +
+
?
0:22:25
+2°C
STOP
46°C
SAVE
- +
+