irinox Freddy 60 - Page 43

Freddy 43
Press on the central active area to view the time your food will be ready (i.e.
low temperature cooking phase end). This value is a read only value and is
updated when it is edited in the previous screens.
Press again on the central active area to view the food ready time and go
back to the previous screen.
By pressing the
STOP
key for 1 sec. the cycle is stopped and you go back to
the initial hot functions screen.
If the initial cold storage is not present (set time equal to zero) or is nished,
the unit switches to low temperature cooking phase. The display shows the
time left (countdown) of the low temperature cooking phase.
This time can be edited by pressing .
The screen to change the time you wish the food to be ready will be
displayed: this screen changes the time of the cooking phase in progress.
To edit the time press the
+
-
keys to increase or decrease the time by 1
minute. If you wish to increase or decrease the time in a faster manner, use
the horizontal dragging.
Press the
SAVE
key to conrm the time modication, while press to go
back to the previous screen without saving any change.
By pressing the
STOP
key for 1 sec. the cycle is stopped and you go back to
the initial hot functions screen. The chamber temperature detected by the air
probe is shown at the top right-hand side of the display .
Once the cycle is ended, the appliance emits a sound signal. At the end of the
low temperature cooking cycle the following will appear ashing slowly
for 10 sec. with the ready meal or blast chilling symbol next to it, depending
on the selection previously made.
By pressing the
STOP
key for 1 sec. the cycle is stopped and you go back to
the initial hot functions screen. The chamber temperature detected by the air
probe is shown at the top right-hand side of the display .
?
0:22:25
+2°C
STOP
?
13:15
+46°C
STOP
?
0:22:25
+2°C
STOP
13:15
SAVE
- +
+
+55°C
?
STOP
+55°C
?
STOP