irinox Freddy 60 - Page 44

44 Freddy
After 10 seconds, FREDDY sets automatically to the storage mode previously
selected. In case of hot storage the display shows a grey ring with the symbol
of the ready meal in the middle (+60 °C).
Hot maintenance can last up to 48 h.
During this phase a sound signal is emitted every 12 h to indicate the
appliance operating status, until reaching the maximum time. The
temperature inside the chamber detected by the air probe is shown at the
top right-hand side . Press the key to stop the cycle and go back to
the initial screen.
After 48 h the appliance nishes the cycle in progress and emits three sound
signals. The display shows the message "maximum time elapsed".
By pressing in the "maximum time elapsed" information window you will
go back to the main screen.
If cold maintenance is selected, after 10 seconds FREDDY sets automatically
to blast chilling cycle, the displays shows the relevant cycle screen, in manual
mode with timer and default values (2 h).
Cold maintenance, after blast chilling phase, can last up to 48 h.
During this phase a sound signal is emitted every 12 h to indicate the
appliance operating status, until reaching the maximum time.
By pressing the
STOP
key for 1 sec. the cycle is stopped and you go back to
the initial hot functions screen. The chamber temperature detected by the air
probe is shown at the top right-hand side of the display .
After 48 h the appliance nishes the cycle in progress and emits three sound
signals. The display shows the message "maximum time elapsed".
By pressing in the "maximum time elapsed" information window you will
go back to the main screen.
?
+60°C
+
MAXIMUM
TIME ELAPSED
CLEANING THE CELL
COLD
FUNCTIONS
HOT
FUNCTIONS
+8°C
?
STOP
0:15:28
+3°C
?
+
MAXIMUM
TIME ELAPSED
CLEANING THE CELL
COLD
FUNCTIONS
HOT
FUNCTIONS