irinox Freddy 60 - Page 47

Freddy 47
Press on the central active area to view the temperature set at the core of the
food.
Press again on the central active area that shows the temperature set at the
core of the food to go back to the previous screen.
By pressing the
STOP
key for 1 sec. the cycle is stopped and you go back to
the initial hot functions screen.
If the initial cold storage is not present (set time equal to zero) or is nished,
the unit switches to low temperature cooking phase. The display shows the
temperature read by the core probe during low temperature cooking phase.
Press on the central active area to view the time elapsed from the start of the
cooking phase. This value is a read only value and is updated when it is edited
in the previous screens.
By pressing the
STOP
key for 1 sec. the cycle is stopped and you go back to
the initial hot functions screen. The chamber temperature detected by the air
probe is shown at the top right-hand side of the display .
Once the cycle is ended, the appliance emits a sound signal. At the end of the
low temperature cooking cycle the following will appear ashing slowly
for 10 sec. with the ready meal or blast chilling symbol next to it, depending
on the selection previously made.
By pressing the
STOP
key for 1 sec. the cycle is stopped and you go back to
the initial hot functions screen. The chamber temperature detected by the air
probe is shown at the top right-hand side of the display .
?
0:22:25
+2°C
STOP
?
45°C
+2°C
STOP
?
45°C
+2°C
STOP
?
+2°C
STOP
0:15:28
+55°C
?
STOP
+55°C
?
STOP