54 Freddy
Press on the central active area to view the time your food will be ready (i.e.
heating phase end). This value is a read only value and is updated when it is
edited in the previous screens.
Press again on the central active area to view the food ready time and go
back to the previous screen.
By pressing the
STOP
key for 1 sec. the cycle is stopped and you go back to
the initial hot functions screen.
If the initial cold storage is not present (set time equal to zero) or is nished,
the unit switches to reviving phase.
The display shows the time left (countdown) of the reviving phase. This time
can be edited by pressing .
The screen to change the time you wish the food to be ready: this screen
changes the time of the ready meal cycle in progress. To edit the time press
the
keys to increase or decrease the time by 1 minute. If you wish to
increase or decrease the time in a faster manner, use the horizontal dragging.
Press the
key to conrm the time modication, while press to go
back to the previous screen without saving any change.
By pressing the
key for 1 sec. the cycle is stopped and you go back to
the initial hot functions screen. The chamber temperature detected by the air
probe is shown at the top right-hand side of the display.
At the end of the cycle, the appliance emits a sound signal that is repeated
again after 3 minutes. At the end of the ready meal cycle, the following
will appear slowly pulsing. This is to indicate that FREDDY has set
automatically to the storage phase (+60 °C) that can last up to 48 h.
During this phase a sound signal is emitted every 12 h to indicate the
appliance operating status, until reaching the maximum time.
The temperature inside the chamber detected by the air probe is shown at
the top right-hand side . Press the key to stop the cycle and go back
to the initial screen.
?
+60°C
?
0:22:25
+2°C
STOP
?
0:22:25
+2°C
STOP
?
13:15
+46°C
STOP
13:15
SAVE
- +
To Next Page
