EasyManuals Logo

iStorage datAshur Pro2 User Manual

iStorage datAshur Pro2
42 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
#13
www.istorage-uk.com
iStorage datAshur PRO
2
®
User Manual v2.1
11. Adding a New User PIN in Admin Mode
PIN requirements:
• Must be between 7-15 digits in length
• Must not contain only repetitive numbers, e.g. (3-3-3-3-3-3-3)
• Must not contain only consecutive numbers, e.g. (1-2-3-4-5-6-7), (7-8-9-0-1-2-3-4), (7-6-5-4-3-2-1)
• The SHIFT ( ) button can be used for additional PIN combinations - e.g. SHIFT ( ) + 1 is a different value
than just 1. See section 8, ‘Setting a User PIN Policy’.
To add a New User PIN, first enter “Admin Mode” as described in section 5. Once the drive is in Admin Mode
(solid BLUE LED) proceed with the following steps.
1. In Admin mode press and hold down both
KEY ( ) + 3 buttons
Solid BLUE LED will change to blinking GREEN
and solid BLUE LEDs
2. Enter New User PIN and press KEY ( ) button
Blinking GREEN and solid BLUE LEDs will
switch to a single GREEN LED blink and then
back to blinking GREEN and solid BLUE LEDs
3. Re-enter the New User PIN and press KEY ( )
button again
Blinking GREEN and solid BLUE LEDs change
to a rapidly blinking GREEN LED and finally to a
solid BLUE LED indicating a New User PIN has
been successfully configured
Important: The creation of a new User PIN must comply with the ‘User PIN Policy’ if one has been configured
as described in section 8, which imposes a minimum PIN length and whether a ‘Special Character’ has been
used. Refer to section 10 to check the user PIN restrictions.
Note: When the datAshur PRO
2
is in Admin Mode, the BLUE LED will remain on and solid for 30 seconds only,
during which time the drive can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the datAshur PRO
2
will exit Admin mode automatically - the
solid BLUE LED switches to a solid RED LED which then fades out to the Idle state (all LEDs off).
To immediately exit Admin Mode (solid BLUE LED), press and hold down the SHIFT ( ) button for a second - the
solid BLUE LED switches to a solid RED LED which then fades out to the Idle state. To access the drive contents
(data), the datAshur PRO
2
must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.

Table of Contents

Other manuals for iStorage datAshur Pro2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the iStorage datAshur Pro2 and is the answer not in the manual?

iStorage datAshur Pro2 Specifications

General IconGeneral
BrandiStorage
ModeldatAshur Pro2
CategoryStorage
LanguageEnglish

Related product manuals