iStorage datAshur Pro2 User Manual

#8
iStorage datAshur PRO
2
®
User Manual v2.1
www.istorage-uk.com
5. To Enter Admin Mode
To Enter Admin Mode, do the following.
1. Press and hold down the SHIFT ( ) button
for one second
RED, GREEN and BLUE LEDs blink once in
sequence then the GREEN LED blinks twice and
finally switches to a solid RED LED indicating the
device is in Standby State
2. In Standby State (solid RED LED) press the
KEY (
) button once
GREEN and BLUE LEDs blink together
3. With the GREEN and BLUE LEDs blinking together,
enter the Admin PIN and press the KEY (
) button
again
GREEN and BLUE LEDs will alternately blink
several times and then to a solid BLUE LED
changing to a blinking GREEN LED indicating the
device is unlocked
4. Press the KEY (
) button Three times
within 2 seconds (KEY (
) x 3)
Blinking GREEN LED will change to a solid BLUE
LED indicating the device is in Admin mode
Note: Once datAshur PRO
2
has been successfully unlocked, the GREEN LED will remain blinking for 30 seconds
only, during which time the datAshur PRO
2
needs to be connected to a powered USB port. It can be locked down
immediately (if not connected to a USB port) by pressing and holding down the SHIFT ( ) button for a second
or by clicking the ‘Safely Remove Hardware/Eject’ icon within your operating system when connected to a USB
port.
When the datAshur PRO
2
is unlocked and connected to a USB port, it will not accept further instructions via the
keypad.
6. To Exit Admin Mode
When the datAshur PRO
2
is in Admin Mode, the BLUE LED will remain on and solid for 30 seconds only, during which time
the drive can accept instructions via the keypad allowing it to be configured with a host of security features. If no key event
happens within 30 seconds, the datAshur PRO
2
will exit Admin mode automatically - the solid BLUE LED switches to a solid
RED LED which then fades out to the Idle state (all LEDs off).
To immediately exit Admin Mode (solid BLUE LED), press and hold down the SHIFT ( ) button for a second - the solid
BLUE LED switches to a solid RED LED which then fades out to the Idle state. To access the drive contents (data), the
datAshur PRO
2
must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.

iStorage datAshur Pro2 Specifications

General

Brand	iStorage
Model	datAshur Pro2
Category	Storage
Language	English