iStorage datAshur Pro2 User Manual

#5
www.istorage-uk.com
iStorage datAshur PRO
2
®
User Manual v2.1
1. LED indicators and their actions
LED LED State Description LED LED State Description
RED Solid Locked device (in either
Standby or Reset states)
RED, GREEN and
BLUE Blinking
Waiting for User PIN entry
RED - Fade Out Device Turning off to the
Idle State
GREEN and BLUE
Blinking together
Waiting for Admin PIN entry
GREEN Blinking Unlocked device as Admin
(not connected to USB port)
GREEN and BLUE
Blinking alternately
Authentication in progress
GREEN Solid
Unlocked device as User
(not connected to USB port) or
device in User mode
BLUE blinking every
5 seconds
Battery starts charging after 30
seconds when device is locked
and connected to a USB port
BLUE Solid
Device in Admin mode
2. Battery and LED States
To wake from Idle State
Idle state is defined as when datAshur PRO
2
is not being used and all LEDs are off.
To wake datAshur PRO
2
from the idle state do the following.
Press and hold down the SHIFT ( )
button for one second or connect the device
to a powered USB port
RED, GREEN and BLUE LEDs blink once in sequence then the
GREEN LED blinks twice and finally switches to a solid RED
LED indicating the device is in Standby State
Note: The normal function of the datAshur PRO
2
may be disturbed by strong Electro-Magnetic Interference. If
so, simply power cycle the product (power off then power on) to resume normal operation. If normal operation
does not resume, please use the product in a different location.
The datAshur PRO
2
incorporates voltage detection circuitry that monitors the battery output when the device is powered on.
When battery output drops to 3.3V or below, the RED LED flashes three times and fades out. At this point, the User should
connect the datAshur PRO
2
to a powered USB port and charge for 15-30minutes. Once recharged, the datAshur PRO
2
will
resume normal function.
Low Battery Sensor
To enter Idle State
To force datAshur PRO
2
to enter Idle State, execute either of the following operations:
• If the device is connected to a USB port, disconnect it.
• If the device is not connected to a USB port, press and hold down the SHIFT ( ) button for a second until the LED
turns solid RED and fades out to the Idle State (off).

iStorage datAshur Pro2 Specifications

General

Brand	iStorage
Model	datAshur Pro2
Category	Storage
Language	English