iStorage datAshur Pro2 User Manual

#14
iStorage datAshur PRO
2
®
User Manual v2.1
www.istorage-uk.com
12. Changing the User PIN in Admin Mode
To change an existing User PIN, first enter the “Admin Mode” as described in section 5. Once the drive is in Admin
Mode (solid BLUE LED) proceed with the following steps.
1. In Admin mode press and hold down both
KEY ( ) + 3 buttons
Solid BLUE LED will change to blinking GREEN
and solid BLUE LEDs
2. Enter New User PIN and press KEY ( ) button
Blinking GREEN and solid BLUE LEDs will
switch to a single GREEN LED blink and then
back to blinking GREEN and solid BLUE LEDs
3. Re-enter the New User PIN and press KEY ( )
button again
Blinking GREEN and solid BLUE LEDs change
to a rapidly blinking GREEN LED and finally to
a solid BLUE LED indicating the User PIN has
been successfully changed
Important: Changing the User PIN must comply with the ‘User PIN Policy’ if one has been configured as
described in section 8, which imposes a minimum PIN length and whether a ‘Special Character’ has been
used. Refer to section 10 to check the user PIN restrictions.
Note: When the datAshur PRO
2
is in Admin Mode, the BLUE LED will remain on and solid for 30 seconds only,
during which time the drive can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the datAshur PRO
2
will exit Admin mode automatically - the
solid BLUE LED switches to a solid RED LED which then fades out to the Idle state (all LEDs off).
To immediately exit Admin Mode (solid BLUE LED), press and hold down the SHIFT ( ) button for a second - the
solid BLUE LED switches to a solid RED LED which then fades out to the Idle state. To access the drive contents
(data), the datAshur PRO
2
must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.
13. Deleting the User PIN in Admin Mode
To delete an existing User PIN, first enter the “Admin Mode” as described in section 5. Once the drive is in Admin Mode
(solid BLUE LED) proceed with the following steps.
1. In Admin mode press and hold down both
SHIFT ( ) + 3 buttons
Solid BLUE LED will change to a blinking RED
LED
2. Press and hold down both
SHIFT ( ) + 3 buttons again
Blinking RED LED will change to a solid RED
LED and then to a solid BLUE LED indicating
the User PIN has been successfully deleted

iStorage datAshur Pro2 Specifications

General

Brand	iStorage
Model	datAshur Pro2
Category	Storage
Language	English