EasyManuals Logo

iStorage datAshur Pro2 User Manual

iStorage datAshur Pro2
42 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #17 background imageLoading...
Page #17 background image
#17
www.istorage-uk.com
iStorage datAshur PRO
2
®
User Manual v2.1
Note: When the datAshur PRO
2
is in Admin Mode, the BLUE LED will remain on and solid for 30 seconds only,
during which time the drive can accept instructions via the keypad allowing it to be configured with a host of security
features. If no key event happens within 30 seconds, the datAshur PRO
2
will exit Admin mode automatically - the
solid BLUE LED switches to a solid RED LED which then fades out to the Idle state (all LEDs off).
To immediately exit Admin Mode (solid BLUE LED), press and hold down the SHIFT ( ) button for a second - the
solid BLUE LED switches to a solid RED LED which then fades out to the Idle state. To access the drive contents
(data), the datAshur PRO
2
must first be in the idle state (all LEDs off) before an Admin/User PIN can be entered.
Important: The creation of a new User PIN must comply with the ‘User PIN Policy’ if one has been configured
as described in section 8, which imposes a minimum PIN length and whether a special character has been
used. Refer to section 10 to check the user PIN restrictions.
18. Activating Recovery Mode and Creating New User PIN
The User Recovery PIN is extremely useful in situations where a user has forgotten their PIN to unlock the datAshur PRO
2
.
To activate the recovery mode, the user must first enter the correct One-Time Recovery PIN, if one has been configured. The
user PIN recovery process does not impact the data, encryption key and Admin PIN, however the user is forced to configure a
new 7-15 digit User PIN.
To activate the Recovery process and configure a new User PIN, proceed with the following steps.
1. With the drive in Idle State press and hold down
the SHIFT ( ) button for one second
RED, GREEN and BLUE LEDs blink once in
sequence then the GREEN LED blinks twice and
finally switches to a solid RED LED indicating
the drive is in Standby State
2. In Standby State press and hold down both
KEY ( ) + 4 buttons
Solid RED LED will change to blinking RED and
GREEN LEDs
3. Enter the One-Time Recovery PIN and press the
KEY ( ) button
GREEN and BLUE LEDs alternate on and off then
to a solid GREEN LED and finally to blinking
GREEN and solid BLUE LEDs
4. Enter the New User PIN and press the KEY ( )
button
Blinking GREEN and solid BLUE LEDs change to
a single GREEN LED blink then back to blinking
GREEN and solid BLUE LEDs
5. Re-enter the New User PIN and press the
KEY ( ) button again
GREEN LED blinks rapidly then becomes solid
GREEN indicating the recovery process has
been successful and a new user PIN configured

Table of Contents

Other manuals for iStorage datAshur Pro2

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the iStorage datAshur Pro2 and is the answer not in the manual?

iStorage datAshur Pro2 Specifications

General IconGeneral
BrandiStorage
ModeldatAshur Pro2
CategoryStorage
LanguageEnglish

Related product manuals