Quick Reference
Output Res
Set the internal resistance of the power
supply. This parameter needs to be set
only when Mode is set to CV.
On Delay Set the delay time to turn on the output.
Off Delay Set the delay time to turn off the output.
Voltage Max
Set the upper limit of the voltage (de-
fault is the rated voltage of the instru-
ment). Once the voltage upper limit is
modified here, the parameters related
to the voltage setting will be limited by
the upper limit here.
1.8 System Menu Function
This Chapter offers a general introduction of system menus, allowing users to
have a preliminary understanding of system functions of this series instrument.
The steps of the system menu function are as follows:
1. Press the composite keys [Shift]+[P-set] (System) on the front panel to en-
ter the system menu.
At this point, the VFD screen displays the system menu items. Each menu
item has a numbering identifier. The user can use the knob for scrolling dis-
play of other menu items.
2. Press [Enter] on a menu interface to enter the setting interface.
3. After the menu items are set, press [Enter] again to save the modified
contents.
You can press [Esc] to return to the previous menu.
The description of the menu items is shown in the table below.
Beep Set the beeper state.
On
Turn the beeper on.
Off
Turn the beeper off.
PowerOn
Set the power-on state.
Copyright © Itech Electronic Co., Ltd.
11
To Next Page
Loading...
Need help?
General
