Basic Operation
Category Parameter Initial Value
OVP/OCP/OPP/UCP/UVP Delay
time: Delay
60s
UCP/UVP Warm time: Warm-up
3.6.10 View the System Information (System Info)
This menu item is used to view the system information of the instrument.
The procedures to view the system information are as follows.
1. Press the composite keys [Shift]+[P-set] (System) on the front panel to en-
ter the system menu.
2. Press the Up/Down key or turn the knob to select the System Info and press
[Enter].
You can use Up/Down key or knob to view the following system information.
Parameter Description
Model Display the instrument model.
MAC Addr Display the MAC address, that is, the physical
address.
SN Display the serial number.
Main-Ver Display the system version information.
Ctrl-Ver Display the version information for a single
module.
FPGA-Ver Display the FPGA version information.
INV-Ver Display the control board version information.
2017/6/22 0:00 Display the system time.
3.7 System Upgrade
The IT6000C series power supply supports the upgrade of the system version.
System upgrade includes the following two methods:
Copyright © Itech Electronic Co., Ltd.
60
ООО "Техэнком" Контрольно-измерительные приборы и оборудование www.tehencom.com
To Next Page
Loading...
