Function and Features
pulse width and rise/fall slope of each step. Each wave can set repetition, so
does each list file. Ten wave files can be linked in sequence under one list.
Relationship between List file and wave file is shown below.
List file can select any one from 100 waves. Each List file can select 10 wave
files at most and combine them into a List file based on sequence.
Each wave file has ten steps. The List file can select the wave file and set the
count of repetitions to be executed.
List function menu is as follows.
List List function menu
On/Off List function switch
Recall List file recall
Recall File Name: Need to recall list file
number.
EditFile List file edit
Repeat: count of List file repetitions (0-
65535)
Wave Count: total count of waves
contained in this List file. (1-10)
1st Wave Select: number of the first wave
selected
1st Wave Repeat: count of repetitions of
the first wave selected (0-65535)
Yes/No: save to the file or not
EditWave Wave file edit
Recall Wave: Need to recall Wave file
number.
Copyright © Itech Electronic Co., Ltd.
43
To Next Page
Loading...
Need help?
General
