Inspection and Installation
– IP: This value is the Internet Protocol (IP) address of the instrument. An
IP address is required for all IP and TCP/IP communications with the in-
strument. An IP Address consists of 4 decimal numbers separated by pe-
riods. Each decimal number ranges from 0 through 255 with no leading
zeros (for example, 169.254.2.20).
– Gate: This value is the IP Address of the default gateway that allows the
instrument to communicate with systems that are not on the local subnet,
as determined by the subnet mask setting. The same numbering notation
applies as for the IP Address. A value of 0.0.0.0 indicates that no default
gateway is defined.
– Mask: This value is used to enable the instrument to determine if a client
IP address is on the same local subnet. The same numbering notation
applies as for the IP Address. When a client IP address is on a different
subnet, all packets must be sent to the Default Gateway.
– DNS1: This field enters the primary address of the server. Contact your
LAN administrator for server details. The same numbering notation ap-
plies as for the IP Address. A value of 0.0.0.0 indicates that no default
server is defined.
DNS is an internet service that translates domain names into IP ad-
dresses. It is also needed for the instrument to find and display its host
name assigned by the network. Normally, DHCP discovers the DNS ad-
dress information; you only need to change this if DHCP is unused or not
functional.
– DNS2: This field enters the secondary address of the server. Contact
your LAN administrator for server details. The same numbering notation
applies as for the IP Address. A value of 0.0.0.0 indicates that no default
server is defined.
Operation Steps:
1. Press the composite keys [Shift] + [Select](System) to enter into the system
menu interface.
2. Rotate the knob to select I/O Config and press [Enter] key to confirm.
3. Rotate the knob to select LAN and press [Enter] key to confirm.
4. Rotate the knob to select I/O Advance Config and press [Enter] to enter
the LAN advanced setting interface.
5. Rotate the knob to select IP Config and press [Enter] key to set the instru-
ment address.
6. Rotate the knob to select IP Mode and press [Enter] key to select the IP set-
ting mode.
• Auto: automatically configure the addressing of the instrument;
• Manu: manually configure the addressing of the instrument. If Manu is
selected, set the parameters such as IP and Gate.
7. After setting, press [Esc] to exit.
Copyright © Itech Electronic Co., Ltd.
23
To Next Page
Loading...
