ITech IT8000 Series User Manual

Load Function
Delay Delay time
OPP
Overpower protection
Off Turn the OPP function off.
On Turn the OPP function on.
Level OPP limit
Delay Delay time
UVP
Undervoltage protection
Off Turn the UVP function off.
On Turn the UVP function on.
Level UVP limit
Delay Delay time
Warm-up
Indicates the instrument
warm-up time. This time is
set to prevent the instrument
from triggering protection
when the voltage is rising.
Because this transient condi-
tion should not be considered
as an undervoltage fault and
there is no need to trigger
protection.
Protection Delay
You can specify an OCP/OPP/UVP delay to prevent momentary input settings
and status changes from tripping the protection. In most cases these momenta-
ry conditions would not be considered an protection fault, and having an OCP/
OPP/UVP condition disable the input when they occur would be a nuisance.
Specifying an protection delay (Delay) can ignore these momentary changes
during the specified delay period. Once the delay time has expired and the pro-
tection limit condition persists, the input will shut down.
Protection Prompt
When the instrument enters the protection state, the buzzer sounds (if Beep
menu item is set as default state On), the VFD status indicators Prot and Off
are lit, and [On/Off] is turned off.
Copyright © Itech Electronic Co., Ltd.
60

ITech IT8000 Series Specifications

General

Brand	ITech
Model	IT8000 Series
Category	Test Equipment
Language	English