Basic Operation
5.13 Restored to Factory Setting (System Reset)
This menu item is used to restore some parameter settings to factory setting
values.
The procedures to set the menu item are as follows.
1. Press the composite keys [Shift]+[P-set] (System) on the front panel to en-
ter the system menu.
2. Press the Up/Down key or turn the knob to select the System Reset and
press [Enter].
3. Press the Left / Right key or turn the knob to adjust the value of this
parameter.
• No: Default value, indicates the instrument cancels this menu setting.
• Yes: Indicates the instrument restores the factory default settings.
4. After the parameter settings are complete, press [Enter].
The parameters affected by System Reset and the parameter values after
reset are shown in the following table.
Table 5–3 Initial value of the parameter
Category
Parameter Initial Value
Main
interface
Voltage setting under CV mode:
Vs
Rated voltage of the
instrument
Current setting under CC mode:
Is
0A
Power setting under CW mode:
Ps
0W
Copyright © Itech Electronic Co., Ltd.
103
To Next Page
Loading...
