ITech IT8000 Series User Manual

Basic Operation
• Press the composite keys [Shift]+[+/-] (Save) to save the parameters. Press
the composite keys [Shift]+[0] (Recall) to recall the parameters.
• SCPI commands: *SAV and *RCL
5.3.1 Save Operation
The save operation procedures are as follows:
1. Press the composite keys [Shift]+[+/-] (Save) to enter the parameter save
interface.
2. Set the storage location.
Enter a number in the "Save data to bank=1" to set the storage location in
non-volatile memory.
3. Press [Enter] to save the parameters.
5.3.2 Recall Operation
You can recall the parameters you saved in the specified memory location as
the setting values.
1. Press the composite keys [Shift]+[0] (Recall) to enter the parameter recall
interface.
2. Set the storage location.
Enter a number in the “Recall data from bank=1” to set the storage location
in non-volatile memory.
3. Press [Enter] to recall the parameters.
5.4 Data Logging Function
The IT8000 series Regenerative DC Electronic Load supports the recording
and saving of test data. This Chapter introduces how to use this function in
details.
The user can select the following data sources for recording:
• Voltage
Only records voltage data during the data acquisition period.
• Current
Only records current data during the data acquisition period.
Copyright © Itech Electronic Co., Ltd.
67

ITech IT8000 Series Specifications

General

Brand	ITech
Model	IT8000 Series
Category	Test Equipment
Language	English