Appendix A pg. 2 ITW Dynatec c. 2003
Revised 6/11 DY2008 Controller Manual #50-14
18 110018 Sensor Bracket (fits 108239 & 105178)
19 05.02105.603 Sensor Extension Cable, 5M
20 05.02105.612 Sensor Extension Cable, 10M
21 05.02105.604 Sensor Extension Cable, 25M
22 05.02105.615 “Y” Cable to Connect one sensor to two inputs
Encoders and Cables
23 05.66501.004 Encoder, 1000 PPR (encoder only)
24 70.90000.703 Encoder/Wheel/Bracket Assembly, 1000PPM
25 111420 Encoder/Wheel/Bracket Assembly, 50PPI, includes 5M Cable
26 05.02104.612 Encoder Extension Cable, 5M, 90 degree connector
27 05.02104.601 Encoder Extension Cable, 10M
28 28.20000.004 “Y” Cable to Connect Encoders #3 or #4
29 05.02104.610 “Y” Cable to Connect one encoder to two inputs
Pressure Control Accessories
30 05.67000.705 I/P Transducer Kit, includes one 05.67000.102 (see below)
31 05.67000.706 I/P Transducer Kit, includes two 05.67000.102 (see below)
32 05.67000.102 I/P Transducer EIT201-002B with 5M cable
33 05.67000.706 I/P Transducer EIT601-000 with 5M cable
34 05.02103.603 Transducer Extension Cable, 5M
35 109996 I/P Transducer, includes 3m Cable
Connectors
36 05.03002.001 or
105079
Machine Contact Plug, 2-pin
37 05.03003.003 or
105077
Pressure Control Plug, 3-pin
38 05.03005.002 Pressure Control Plug, 5-pin
39 105076 Encoder Connector Plug, 4-Pin
40 05.03003.005 or
105078
Trigger Connector Plug, 5-Pin
41 05.03003.006 or
109011
Alarm Output Plug, 6-Pin
To Next Page
Loading...