GENERAL SPECIFICATIONS
1-5
DAILY 4X4
Print 603.93.761 Base - May 2007
IVECO technical documents available by means of computer
IV ECO techn ical docu men ts avai l able by means of computer
1.6 IVECO technical documents available by means of computer
The following technical documents are available on the Internet at www.thbiveco.com:
- directives for transformation and equipping of vehicles;
- technical cards;
- chassis cab diagrams;
- chassis diagrams;
- other specifications concerning th e vehicle range.
The body builder shall submit the modification and/or fitting to the competent authorities for approval.
1.7 Trademarks and Logos
Trademarks, nameplates and denominations must not be modified or displaced in relation to the origin al design. Th e appearance
of the vehicle must not be changed or modified.
The application of trademarks tied to th e transformation or trim levels must be authorised by IVECO. They must not be applied
near t o the IVECO tradenames or logos.
IVECO reserves the right to withdraw the tradenames and logos if the fitting or conversion fails to conform with requirements. The
bodybuilder ac c epts all responsibility for the ent ire vehicle.
Instruction for added assemblies
Where assemblies are added, the bodybuilder must provide the necessary service and maintenance instructions when the vehicle
is delivered.
1.8 Legal Provisions
On completing the vehicle, the bodybuilder/chassis converter must ch ec k the work (modifications, body + equipment etc.) to
ensure that th e legal provisions required in the country of registration are observed (e.g. weights, dimensions, braking, noise,
emissions etc.). Information regarding these matters may be obtained from the competent Authorities or the IVECO Area Network.
The vehicles manufactured at our plant (except some versions for Extra-European countries) comply with the EC directives. Conver-
ted vehicles must also comply w ith these directives. Th e only permissible exception is granted where local type approval differs from
EC homologation.