GENERAL SPECIFICATIONS
1-7
DAILY 4X4
Print 603.93.761 Base - May 2007
Vehicle delivery
Vehicle delivery
1.11 Vehicle delivery
Prior to delivering the vehicle, the body builder shall:
- verify that the work has been made correctly;
- perform vehicle and/or equipment set-up;
- check the operation and safety of the vehicle and/or equipment;
- prepare and deliver the necessary instruct ions for service an d maintenance of the fitting and any additional units to the end cu sto-
mer;
- write the new data down on the special tags;
- confirm that the work carried out complies with the indications provided by the vehicle manufacturer and with the law regula-
tions;
- carry out th e ch ecks in cluded in the ”IVECO Pre-Delivery inspection” list (available from th e IVECO network) with regard to
the items affected by the work done;
- provide a guarantee for the modifications made;
- in the event that the connections originally provided with screws have been mounted and restored, the same screws shall not
be used. In such an instance, and in the event that nails have been replaced with sc rews, you must check again the closing of
the connection after travelling approximately 500-1000 km.
- measure th e battery voltage. Ensure there is a minimum charge of 12.5 V. If the voltage reading is between 12.1 and 12.49 V,
recharge the battery (slo w charge). If the voltage is less than 12.1 V, the battery must be scrapped and replaced with a new one;
- the batteries must be serviced at regular intervals until the vehicle is handed over to the cu stomer to prevent problems of low
charge, short-circuits or corrosion. IVECO reserves the right to terminate the battery warranty if the maintenance procedures
required by the IVECO network are not observed.
To Next Page
Loading...
Need help?
General
