2-28
CHASSIS MODIFICATIONS
D
AILY 4x4
Base - May 2007 Print 603.93.761
Installing a Supplementary Axle
The use of original drive line from IVECO is recommended for these modifications. Should this not be possible however, hardened
steel tubes with a yield point of not less than 420 N/mm
2
(42 kg/mm
2
)maybeused.
Modifications to the universal joints are not permitted.
Whenever the transmission or part thereof, is modified, each modified section must be subjected to careful dynamic balancing.
!
Since transmission is important to vehicle driving safety, it should be borne in mind that any
modification to it must bear maximum operational guarantees. Only very specialised and transmission
manufacturer-certified companies should therefore be employed to carry out work of this kind.
To Next Page
Loading...
Need help?
General
