SAFETY
Electrosurgery
Avoid electrosurgery burns at monitoring sites by ensuring proper connection of the electrosurgery return circuit. If
improperly connected, some electrosurgery units might allow energy to return through the electrodes.
Defibrillation Protection
This equipment is protected against 360 J discharge and electrosurgery potentials. The monitor is internally
protected to limit current through the electrodes to prevent injury to the patient and damage to the equipment as long
as the defibrillator is used in conformance with the manufacturer's instructions.
EMC
This equipment has been certified to be protected to emissions and immunity according to IEC-601-1-2.
Description of Warning Labels
Attention, consult ACCOMPANYING DOCUMENTS before attempting to change
power supply selection or carry out interconnections. Equipment connected should
comply with IEC-601-1 or IEC-950 with configuration to IEC-601-1-1.
Equipotential earth connector adjacent to this symbol.
Protective earth (ground) adjacent to this symbol. Internal connection on mains
connector/filter.
⎯⏐
♥⏐⎯ Type CF equipment, Defibrillator proof.
_______
Fuse type/rating.
{ ⏐ { = OFF, ⏐= ON.
∼ Alternate Current (AC)
Output signal.
DANGER
HIGH
VOLTAGE
Model 101R/NR Service Manual 3
To Next Page
Loading...
Need help?
General
