28
07610-004-33-05-E
1. Turn machine off by pressing the Power Button.
2. Open access door and allow steam/heat to escape.
3. Turn drain handle to “OPEN” and allow tub to drain.
WARNING! Wash tank water will be hot.
4. Remove the strainers, hand-scrape foodsoil into trash, and spray with pre-rinse hose.
5. Rinse the float switch off, rinse the tank out, and inspect tank for debris.
6. Remove curtains, scrub with mild detergent and brush, and allow to air-dry.
7. Wash & Rinse Arms:
a. As needed, fill the tub with water.
b. Remove the end-caps from the arms.
c. Run an empty rack through the machine.
d. If necessary:
i. Clean nozzles with a brush.
ii. Use a small wire or toothpick to remove remaining
debris or lime deposits from the nozzles.
iii. Flush the arms with water.
iv. Replace end-caps and ensure they have
been tightened.
SHUTDOWN &
CLEANING
!
WARNING
OPERATION
OPERATING INSTRUCTIONS
Self-cleaning arms do not
require daily cleaning.
To Next Page
Loading...
