SPECIFICATIONS 11
en-112
11.3 MACHINE SPECIFICATION __________________________________________________
Frame construction: Heavy duty steel chassis with formed steel frame rails.
Cutter Deck Drive: HR800, Nine individual hydraulic motors with self lubricating integral bearings.
Transmission: Hydrostatic closed loop parallel cross series SureTrac system. Variable displacement piston pump.
Front high torque two speed piston wheel motors. Full time auto 4WD forward, on demand 4 WD in reverse.
Speeds:
Cutting: 0 - 17.7 km/h (0 - 11 mph) Forward
0 - 9.6 km/h (0 - 6 mph) Reverse
High Speed 0 - 32.2 km/h (0 - 20 mph) Forward
Transport: 0 - 16.1 km/h (0 - 10 mph) Reverse
Low Speed 0 - 25 km/h (0 - 15.5 mph) Forward
Transport: 0 - 6.4 km/h (0 - 6 mph) Reverse
Creep: 0 - 8 km/h (0 - 5 mph) Forward
0 - 5 km/h (0 - 3.1 mph) Reverse
Steering: Q-AMP
®
variable rate hydrostatic powered equal displacement cylinder to rear wheels.
Ground pressure: Depends on the tire pressures and the accessories installed.
Brakes: Hydrostatic braking with wet disc parking brakes on the front wheels.
Battery: BBMS 678 80-capacity 20 Amp Hours 540A
Cab Climate Control:
Technical data
Air conditioning system
Heating Performance 6.0 kW
Cooling performance 4.5 kW
Refrigerant R 134A
Recommended refrigerant level 800 g
Operating voltage 12 V
Power consumption, clutch max.49W
Refrigerant Oil 135 cc
Refrigerant Oil - in the compressor 50 cc
To Next Page
Loading...
Need help?
General
