MAINTENANCE AND LUBRICATION 7
en-80
Check The Engine Coolant Level
a The level of coolant in a cold expansion tank must be between the
indicators.
b If you need to fill the tank, remove the plastic cap and fill with the correct
anti-freeze mixture (See Section 7.1).
c Replace the plastic cap.
How To Change Coolant
a To drain coolant, remove the bottom hose (A) from the radiator.
Drain the engine coolant into a container.
b Replace the bottom hose (A) on to the radiator. Make sure all
the hose clips (B) are tight.
c Fill the cooling system with the correct anti-freeze mixture (See
Section 7.1). Fill system through the radiator cap.
d The level of coolant in a cold expansion tank must be between
the indicators.
e Run the engine for approximately 5 minutes or until the
thermostat opens.
f Check the level of coolant in expansion tank. Fill the tank if more coolant is needed.
CAUTION
The Anti-freeze Can Damage Your Skin. Use Gloves When You Use Anti-freeze. If Anti-freeze Touches Your
Skin, Clean The Area Immediately.
CAUTION
Discard Anti-freeze As Shown In Local Safety Regulations.
To Next Page
Loading...
Need help?
General
