Page 11
Auxiliary Equipment
The AUX modes control each of the auxiliary devices plus an extra AUX. To assign a different name to an auxiliary
device, use the SYSTEM SETUP and LABEL AUX menus.
To turn an Auxiliary on or off
Highlight an AUX and press SELECT. Use the SELECT button to turn the equipment on or off.
Heat Pump
NOTE This equipment may not be part of your system. Please check with your installer.
The HEAT PUMP selection controls the heat pump operation. In order to use the heat pump, the filter pump must be
turned on and the heat pump must be in HEAT MODE (see page 23, Using the System Setup Menu), and the switch
on the heat pump on the equipment pad must also be set to HEAT MODE.
NOTE HEAT PUMP takes the place of EXTRA AUX or SOLAR HEAT. It is not possible to have any two of these on the
EQUIPMENT ON/OFF menu at the same time.
To use Heat Pump
Highlight HEAT PUMP and press SELECT. Press the SELECT button to enable/disable the HEAT PUMP. The HEAT
PUMP uses the heater temperature set point.
HEAT PUMP
FILTER PUMP ON
SPA
POOL HEAT
SPA HEAT
HEAT
AUX 1
AUX 2
AUX 3
AUX 4
AUX 5
AUX 6
AUX 7
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
FILTER PUMP ON
SPA
POOL HEAT
SPA HEAT
AUX 1
AUX 2
AUX 3
AUX 4
AUX 5
AUX 6
AUX 7
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
ENA
PUMP
FILTER PUMP ON
SPA
POOL HEAT
SPA HEAT
SOLAR HEAT
AUX 2
AUX 3
AUX 4
AUX 5
AUX 6
AUX 7
AUX 1
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
FILTER PUMP ON
SPA
POOL HEAT
SPA HEAT
SOLAR HEAT
AUX 2
AUX 3
AUX 4
AUX 5
AUX 6
AUX 7
AUX 1
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
ON
To Next Page
Loading...
Need help?
General
