Page 26
Degrees C/F Menu
The Degrees C/F menu allows you to change the AquaLink RS temperature display from Fahr en heit to Celsius or vice
versa. When changing from Fahrenheit to Celsius you will have to re-enter the temperature settings.
To change the Temp readout
Highlight MENU/HELP and press SELECT, highlight SYSTEM SETUP and press SELECT, highlight DEGREES
C/F and press SELECT. Use the UP/DOWN arrow keys to highlight desired setting and press SELECT.
Temp Calibration Menu
This menu allows adjustment of the temperature that is displayed on the AquaLink RS. The temperature can only be
adjusted up 4 degrees Fahrenheit or down 4 degrees Fahrenheit, see note below.
To adjust Temperature display
Highlight MENU/HELP and press SELECT, highlight SYSTEM SETUP and press SELECT, highlight TEMP
CALIBRATE and press SELECT. Use the UP/DOWN arrow keys to set values and press SELECT when finished.
NOTE If the temperature is off by more than four (4) degrees, contact your local service representative.
Daylight Savings Menu
The DAYLIGHT SAVINGS menu enables the automatic adjustment for Daylight Savings Time.
To set up Daylight Savings
Highlight MENU/HELP and press SELECT, highlight SYSTEM SETUP and press SELECT, highlight DAYLIGHT
SAVINGS and press SELECT. Use the UP/DOWN arrow keys to highlight ENABLED or DISABLED and press
SELECT. Default setting is ENABLED.
SYSTEM SETUP
ONETOUCH
LABEL AUX
FREEZE PROTECT
AIR TEMP
DEGREES C/F
TEMP CALIBRATE
IN FLOOR CLEAN
SOLAR PRIORITY
MORE
DEGREES C/F
Choose setting
and press SELECT
FAHRENHEIT
CELSIUS
SYSTEM SETUP
ONETOUCH
LABEL AUX
FLOWLINK SETUP
FREEZE PROTECT
AIR TEMP
DEGREES C/F
DAYLIGHT SAVIN
TEMP CALIBRATE
MORE
AUTO
DAYLIGHT SAVINGS
TIME CHANGE
ENABLED
DISABLED
Choose setting
and Press SELECT
SYSTEM SETUP
ONETOUCH
LABEL AUX
FREEZE PROTECT
AIR TEMP
DEGREES C/F
TEMP CALIBRATE
IN FLOOR CLEAN
SOLAR PRIORITY
MORE
TEMP CALIBRATE
Use ARROW KEYS
to set value.
Press SELECT
when finished.
WATER TEMP
80°F
To Next Page
Loading...
Need help?
General
