Page 8
Heater Buttons
The HEATER buttons enable the heater for the pool or spa. The solar heater button controls solar heating. When the
green LED above a HEATER button is il lu mi nat ed, that heater is enabled (i.e., ready to heat, but not heating). When
the red LED above a HEATER button is illuminated, that heater is on (i.e., firing).
Solar Heat requires an optional solar sensor to operate. For solar heating to take place, the solar heater button must
be pressed, the filter pump must be on, the solar temperature must be at least 5º above the water temperature, and the
water temperature must be below the AquaLink RS thermostat setting.
If a Solar Sensor is not installed, the solar heater button may be used to control an auxiliary water feature. Check with
your installer.
Heater Buttons on Pool Only/Spa Only Units
TEMP 1 is the priority (high) temperature. It must be set higher than TEMP 2, and it overrides TEMP
2 whenever it is enabled. Set temperature for TEMP 1 before setting temperature for TEMP 2.
TEMP 2 is the maintenance (low) temperature. It must be set lower than TEMP 1. If TEMP 2 is on
and TEMP 1 is activated, TEMP 2 will turn off and its LED will fl ash. When TEMP 1 is turned off
again, TEMP 2 will reactivate.
To use the Heater Buttons
Press the HEATER button corresponding to the body of water you wish to heat. Press the SOLAR HEATER button
if you want to use solar heat. The heater will only come on if the water is cir cu lat ing (i.e., filter pump is on) to the
corresponding body of water (i.e., SPA for spa heater) and the actual water temperature is below the tem per a ture you
set with TEMP SET in the Menu. If these conditions are not met, the heater will be enabled (ready to go), but will not
fire. When the heater is enabled, the LED next to the button will be green. When it is firing, the LED will turn red.
Display Hold/Release Button
The DISPLAY HOLD/RELEASE button locks the AquaLink RS display that cycles through displays of time, date,
temperature and equipment status (for example, PUMP OFF).
To use Display Hold/Release Button
Press the DISPLAY HOLD/RELEASE button once to lock the AquaLink RS display on the desired message or readout. Press it
again to release it, allowing the display to cycle through messages.
To Next Page
Loading...
